Page text

Division 07 – Thermal and Moisture Protection
OPL Design No. CEJ 260P
07 84 00 Fire stopping
07 84 53 Building Perimeter Fire stopping
Page 4 of 4
Date Revised: June 20, 2014
©Intertek
Project No: 100141291SAT-007
width installed in a known nominal
joint width. (** Listed with Intertek)
B. CERTIFIED
MANUFACTURER:
Hilti, Inc.
CERTIFIED
PRODUCT:
Joint
Spray or Sealant
MODEL: Firestop Joint SprayCFS-
SP WB or Silicone Joint Spray CFS-
SP SIL
Fill, Void or Cavity Material: To be
applied
(sprayed,
Brushed,
or
painted) to cover the exposed
surface of the mineral wool installed
in the perimeter joint. Apply at the
thickness specified in Table 1 and
overlap the material a min. 1/2 in.
onto with Barrier Insulation (2E) and
Concrete Floor Assembly (1). If the
spraying process is stopped and the
applied
liquid
cures
to
an
elastomeric film before process is
restarted, then overlap the edge of
the cured material at least 1/8 in.
with the spray. Reference Product
Section of this Directory for more
details about the Listed product.
C. Support Angle: Standard 1-1/2 x 1-
1/2 in.  min. 20 GA galvanized steel
angle attached between all studs
with self tapping self drilling screws.
Set angle at mid height of Packing
Material (3A).
D.  Support Clips: (Not Shown) Support
clips are optional but recommended
for installations subject to vertical
shear
movement.
Standard
Z-
shaped clips are 20 GA galvanized
steel with the following dimensions:
1 in. wide by 3 in. high with a 2 in.
upper leg and 3 in. lower leg.
**  Before
testing,
the
spliced,
test
specimen was cycled 500 times at 30
cpm according to ASTM E 1399 and
ICBO ES AC 30 (Jan. 1997).