Page text

MSDS302C,  Page 2 of 2
FIRST AID MEASURES
Eyes:
Flush with water if dust, debris, etc. from work overhead gets into eyes.  Do not rub eyes as this
can cause corneal abrasion.  Call a physician if irritation continues, or if redness, swelling, or
similar symptoms occur.
Skin:
Practice good hygiene; i.e. wash hands during breaks, before eating or smoking and after work.
Inhalation:
No first aid should be needed.  If ill effects occur, move to fresh air.  If symptoms persist, seek
medical attention.
Ingestion:
Not a likely route of exposure.
Other:
Referral to a physician is recommended if there is any question about the seriousness of the
injury/exposure.
PREVENTIVE MEASURES
Engineering controls:
General (natural or mechanically induced fresh air movements).
Eye protection:
Safety glasses are recommended for most industrial settings.
Skin protection:
None required; however (cotton) gloves are recommended.
Respiratory protection:
None normally required.
Other:
No additional measures are normally required.
Handling procedures and
equipment:
No special requirements.  Follow installation instructions.
Storage requirements:
Store in a cool dry area.
Spill, leak or release:
No special requirements.
Waste disposal:
Consult federal, provincial, and local regulations for allowed means of disposal.
Special shipping instructions:
None known.
REGULATORY INFORMATION
WHMIS classification:
None (exempt/manufactured article)
HMIS codes:
Health 0,  Flammability 0,  Reactivity 0,  PPE A
IATA/ICAO Shipping Name;
Not regulated.
TDG shipping name:
Not regulated.
PREPARATION INFORMATION / CONTACTS
Prepared by:
Hilti, Inc., Tulsa, OK
USA
Date of Preparation:
April 9,2008
Emergency phone
number:
1 800 424 9300
Customer Service:
Hilti (Canada) Corporation, Mississauga, Ontario;  1 800 363 4458
Health / Safety contacts:
Hilti, Inc., Tulsa, OK USA; 1 800 879 6000,  Jerry Metcalf  (x6704)
Abbreviations used:
N/E = None Established.  N/Ap = Not Applicable.  N/Av = Not Available. HMIS:  Hazardous
Materials Identification System
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or
warranty of any kind expressed or implied is made with respect to the information provided.